How to reset Billion BiPAC 7401VP password?
If you've forgotten your Billion Network Router login or password, first try the default login information. If that doesn't work, restore the router to its factory settings by holding the Reset button on the back of the router for more than 6 seconds.
How to restore the default password on Billion Network Router?
First, try the default login and password, refer to Chapter 3. If this fails, you can restore your router to its factory settings by holding the Reset button on the back of your router for more than 6 seconds. After pressing the RESET button for more than 6 seconds, be sure to power cycle the device again.
Why does my Billion Network Router frequently disconnect?
Frequent disconnections of your Billion Network Router can be caused by missing or incorrectly installed line filters. Make sure all devices connected to the same phone line (telephones, fax machines, modems) have a line filter between them and the wall socket. If you have a Central Splitter or Central Filter installed by an electrician, this isn't necessary. Ensure all line filters are correctly installed.
What to do if the Billion BiPAC 7401VP PVC connection fails?
If the PVC connection fails to initialize on your Billion Network Router, ensure the telephone cable is properly connected from the ADSL port to the wall jack, and that the ADSL LED is on. Also, verify that your VPI, VCI, encapsulation type, and multiplexing settings match those provided by your ISP. Reboot the router. If problems persist, confirm these settings with your ISP.
What to do if Billion Network Router LEDs are not on?
Check the connection between the adapter and the Billion Network Router. If the LEDs are still off, contact technical support.
Why does my Billion BiPAC 7401VP keep disconnecting?
Frequent loss of ADSL linesync (disconnections) can occur if other devices connected to the same telephone line (telephones, fax machines, analogue modems) do not have a line filter connected between them and the wall socket. Ensure that all line filters are correctly installed. Missing or incorrectly installed line filters can cause frequent disconnections.
What to do if I can't ping any PCs on the LAN with my Billion Network Router?
First, check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC connected. If it is off, check the cables between your router and the PC. Also, make sure you have uninstalled any software firewall for troubleshooting. Second, verify that the IP address and the subnet mask are consistent between the router and the workstations.
What to do if initialization of the PVC connection failed on my Billion BiPAC 7401VP?
Ensure that the telephone cable is connected properly from the ADSL port to the wall jack. The ADSL LED on the front panel of the router should be on. Check that your VPI, VCI, encapsulation type and type of multiplexing settings are the same as those provided by your ISP. Reboot the router. If you still have problems, you may need to verify these settings with your ISP.
What to do if no LEDs are on when I turn on my Billion BiPAC 7401VP?
Check the connection between the adapter and the router. If the error persists, you may have a hardware problem. In this case you should contact technical support.
General| Brand | Billion |
|---|---|
| Model | BiPAC 7401VP |
| Category | Network Router |
| Language | English |
To Next Page