The Rear Ports
Port Meaning
1
Power Switch Power ON/OFF switch
2
PWR Connect the supplied power adapter to this jack.
3
RESET
To be sure the device is being turned on->press RESET button for:
1-3 seconds: quick reset the device.
6 seconds above, and power off, power on the device: restore
to factory default settings. (Cannot login to the router or forgot your
Username/Password. Press the button for more than 6 seconds).
Caution: After pressing the RESET button for more than 6
seconds, to be sure you power cycle the device again.
4
LAN
1X — 4X
(RJ-45 connector)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
5
CONSOLE
Connect a PS2/RS-232 cable to this port when connecting to a
PC’s RS-232 port (9-pin serial port).
6
LINE
1X — 2X
(RJ-11 connector)
Connect the supplied RJ-11 (“telephone”) cable to this port when
connecting to the SHDSL line.
＊
＊＊
＊
Only the BiPAC 8520 has two Line jack ports. BiPAC 8500 has one.
To Next Page
Loading...
Need help?
General
