How to reset Billion Network Router password?
If you have forgotten your login username or password for your Billion Network Router, try using the default username 'admin' and password 'admin'. If this doesn't work, restore your router to its factory settings by pressing the reset button on the rear side of the device.
What to do if I cannot PING any PC on Billion BiPAC 4700ZUL Network Router LAN?
If you cannot PING any PC on your Billion Network Router LAN, here are a few things you can check: * First, check the Ethernet LEDs on the front panel. The LED should be on for the port that has a PC connected. If it is not lit, ensure the cable between your router and the PC is properly connected. * Second, make sure you have uninstalled your firewall program before troubleshooting. * Third, verify that the IP address and the subnet mask are consistent for both the router and the workstations.
What to do if no LEDs are on on my Billion BiPAC 4700ZUL?
If none of the LEDs are on when you turn on your Billion Network Router, check the connection between the router and the adapter. If the problem persists, it is most likely due to a hardware malfunction. Please contact your service provider for technical support.
What to do if Billion Network Router LEDs display incorrectly?
If the front LEDs on your Billion Network Router are displaying incorrectly, and you cannot access the router management interface after pressing the RESET button, or if the software/firmware upgrade failed, follow these steps: 1. Configure your PC's IP address to 192.168.1.100. 2. Power off the router. 3. Press and hold the reset button while powering on the router. Once the Power LED flashes Red and Green, keep pressing the reset button for over 6 seconds. 4. When the Internet LED flashes Green and Red, the router has entered the recovery procedure, and its IP will reset to the Emergency IP address (192.168.1.1). 5. Open a browser and go to http://192.168.1.1 to upload the firmware. 6. The Internet LED will light Red, and the router will start writing the firmware into flash. Do n...
Provides crucial safety and usage guidelines for the router.
Explains the procedure for using the reset button for recovery.
Step-by-step instructions for inserting the SIM card.
Guide on assembling cable glands and powering on the device.
Details default login credentials and IP settings.
Steps to access the router's web interface.
Wizard for quick setup of password, time zone, and WAN settings.
Configuration options for Internet, LAN, and Loopback interfaces.
Configuration for the 4G/LTE and EWAN connections.
Configuration for the Local Area Network settings.
Access to advanced features like Firewall, Routing, NAT.
Configuration for the router's firewall and SPI settings.
Overview and setup for various VPN types.
Details on Internet Protocol Security (IPSec) configuration.
Configuration parameters for establishing IPSec tunnels.
Configuration for the PPTP VPN server.
Configuration for the PPTP VPN client.
Details on Layer 2 Tunneling Protocol (L2TP) for VPNs.
Configuration for Generic Routing Encapsulation (GRE) tunnels.
Details on OpenVPN for secure virtual private networks.
Configuration parameters for the OpenVPN server.
Configuration parameters for the OpenVPN client.
Updating firmware and managing configurations.
Common router issues and suggested solutions.
Troubleshooting common LAN connectivity problems.
Steps to recover the router from issues like firmware failure.
General| WAN Ports | 1 |
|---|---|
| Security | WEP, WPA, WPA2, WPS |
| VPN Support | IPSec, PPTP, L2TP |
| LAN Ports | 4 |
| Wireless Standard | 802.11g |
| DSL Standard | ADSL2+, VDSL2 |
| Weight | 0.4 kg |
| Device Type | ADSL2+/VDSL2 Wireless-N VPN Firewall Router |
To Next Page
