39
Internet
4G/LTE
Status: Choose Activated to enable the 3G/4G-LTE connection.
Usage Allowance: to control 4G/LTE flow, click it to further configure about 4G/LTE flow control, refer
to the following Usage Allowance for more information.
LTE PCI Lock: Choose whether to lock to a specified PCI(Physical Cell Identifier). Users must know
the target PCI or else ignore this setting. See LTE PCI Lock for more information.
IP Pass-Through Mode: When enabled, the device will gain a WAN IP via 4G/LTE dial-up and pass
on to the PC connected to device, thus your PC gets a public WAN IP working on the internet. Note:
under this circumstance, often only one PC is connected to the device.
Network Mode: There are some options of service standards: Automatic, UMTS 3G only, GSM 2G
Only, LTE Only. If you are not sure which mode to use, you may select Automatic to auto detect the
best mode for you.
PLMN Selection: Enter or press Scan button to detect a cloest base station(mobile service provider)
from where you are. See PLMN Selection for more information.
TEL No.: The dial string to make a GPRS / 3G/4G-LTE user internetworking call. It may provide by
your mobile service provider.
Dual APN: The Router can support up to two APNs. Select Single or Dual.
APN: An APN is similar to a URL on the WWW, it is what the unit makes a GPRS / UMTS call. The
service provider is able to attach anything to an APN to create a data connection, requirements for
To Next Page
Loading...
Need help?
General
