22
4G/LTE Status
This page contains 4G/LTE connection information.
Status: The current status of the 4G/LTE connection.
Signal Strength: The signal strength bar and dBm value indicates the current 4G/LTE signal strength.
The front panel 4G/LTE Signal Strength LED indicates the signal strength as well.
Signal Information: Shows important LTE signal parameters such as RSRP (Reference Signal
Receiving Power), RSRQ (Reference Signal Receiving Quality), SINR (Signal to Interference plus
Noise Ratio).
RSRP (Reference Signal Receiving Power): is the average power of all resource elements which
carry cell-specified reference signals over the entire bandwidth.
RSRQ (Reference Signal Receiving Quality): measures the signal strength and is calculated
based on both RSRP and RSSI.
SINR (Signal to Interference plus Noise Ratio): is also a measure of signal quality as well. It is
widely used by the operators as it provides a clear relationship between RF conditions and
throughput. Note: Some LTE modules do not provide this information.
Network Name: The name of the LTE network the router is connecting to.
Cell ID: The ID of base station that the device is connected to.
Card IMEI: The unique identification number that is used to identify the 4G/LTE module.
Card IMSI: The international mobile subscriber identity used to uniquely identify the user of a celluar
network – a number provisioned in the SIM card..
Network Mode: Show the using network mode.
Network Band: Show the using network band.
Amount used: Show the volumn used, the amount can be refered to only Download, only Upload
and Download and Upload, please move to Usage Allowance to check.
To Next Page
Loading...
Need help?
General
