31
10 "Beeps”) is made to tell you to insert the food in the oven, and also the programmed
cooking will start that will end at the end of the set time.
The function contains 31 cooking and reheating programs, the list of which
(F-00, F-01, F-02, ....F-31) is shown in the table below, including details of
food, times, temperature and weight. When the function is selected, the
symbols and flash, as does the display, which shows No. “ F-00 “:
Press the knob to access the programme, and turn it to select the function No. (F-00, F-01,
F-02, ....F-31) , and then press it to confirm the selection. The display stops flashing and the
selected programme starts. At the same time, the key that allows changing the
program time lights up, operating as described in the previous paragraph: when the new
time is confirmed, cooking/heating starts again and will end when the set time has expired.
When the function is selected, the symbols and on the knob flash:
press the knob to access the programme and to adjust the parameters.
The display now flashes the time (00:20): turn the knob to increase or decrease the time,
and press it to confirm the selection. The display now flashes the temperature (55): turn the
knob to increase or decrease the temperature, and press it to confirm the selection. The
display stops flashing, the programmed heating starts and ends when the set time expires.
00:05
02:00 55
-60
When the function is selected, the symbols and on the knob flash:
press the knob to access the programme and to adjust the parameters.
The display now flashes the time (00:40): turn the knob to increase or decrease the time,
and press it to confirm the selection. The display then flashes the temperature (40): turn the
knob to increase or decrease the temperature, and press it to confirm the selection. The
display stops flashing, the programmed heating starts and ends when the set time expires.
range
To Next Page
Loading...
General