12/40
INSTALLATION
After removing the packing materials, check the integrity of the appliance; if
you are unsure, do not use it and ask for qualified professional help. The
packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out
the reach of children because they are potential sources of danger. Attention:
any stickers or advertising material applied to the grid removed before using
the appliance. The manufacturer declines all responsibility in case this is not
safe working practices will be respected.
Before connecting the appliance, check that the voltage values shown on the
data plate correspond to those of the electricity supply network. In the event
of incompatibility between the electric outlet and the plug of the appliance,
have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the heater. In general, the use
of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their
current capacity (amperes) must not be less that the maximum of the
appliance.
The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
Do not place the appliance near an open flame, cooking or other heating
appliance.
Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
Stand the appliance on a horizontal, flat surface; do not stand on a inclined
plane (the appliance could upset).
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled,
that is complete with its base and support and protection grid. If in doubt, have
the appliance checked or assembled by a qualified professional person
Attention: always unplug the appliance before you assemble.
For assembly, refer to figure.
To Next Page
Loading...
Need help?
General
