BEFORE FIRST USE
Carefully remove all packaging and assemble the product following the setup & operating
instructions below.
SETUP INSTRUCTIONS
1. Loosen & remove the screw from the stand tube. Insert the stand tube through the hole in
the base & insert the screw to the flange & tighten it.
2. Adjust the telescopic tube to the desired height & lock in place by tightening the height
adjustable collar.
3. Loosen & remove the screw from the plinth and install the motor unit onto the plinth.
4. Loosen & remove the 4 screws from the motor and mount the rear guard.
5. Install the fan blade onto the shaft – ensuring that the holding screws is locked to the
shaft.
6. Install the front guard
After assembly – to avoid accidents – check all parts are tightly fixed and ensure the blades
do not collide with the grills.
OPERATING INSTRUCTIONS
1. Make sure that the fan is on a firm and level surface.
2. Plug the cord of fan into a standard AC 230V outlet.
3. The speed of the fan can be selected by speed knobs on the control panel.
• 0 knob – press to turn “off” the fan.
• 1 knob – press for low gentle, quiet operation.
• 2 knob – press for medium normal use.
• 3 knob – press for high quick cooling and maximum desired air movement.
4. Fan head can be oscillated from left to right.
To operate – loosen the regulation screw below the oscillating plate.
To stop the oscillation – tighten the regulation screw
5. Fan head can be tilted up and down.
To tilt the head, simply move the motor housing up or down gently until the fan is
positioned as required. A series of clicks will be heard - this is normal.
To Next Page
Loading...