Bintelli Havoc - Rear Wheel Removal and Installation

35
USER’S MANUAL Service and Maintenance
Removal and Installation of the Rear Wheel
* Verify the engine is off.
* Place vehicle on center kick stand and remove muffler.
* Loosen the rear wheel nut, and remove the rear wheel.
Installation precautions:
* Torque the rear wheel nut to 80ft.lbs. and reinstall muffer.
* Verify the rear brake is adjusted properly.
If the tread depth in the middle of the tire reaches the following limits the
tire must be replaced immediately.
Minimum limit of tread
depth
Front wheel
5/64 inch
Rear wheel
5/64 inch
Caution
* Low tire pressure will increase the rolling resistance of vehicle,
increase fuel consumption and
wear the tire prematurely. In more
severe cases it can lead to blow outs. Always check tire pressure
prior to riding.
* Excessive tire pressure will cause uneven tire wear, increase the risk
for blow outs, and decrease vehicle stability.
Muffler
Rear Wheel Nut
Check the tread
wear depth of the
tir
e and inspect for
damage
. If any
abnormal
ity is
found,
the tire must
be
replaced
immediately.