Bio-Logic VMP-300-based - Booster Board Calibration Process

Manual for VMP300-based instruments
84
8.2.2 Booster board calibration
16) Select the
appropriate amplifier
with the drop-down
box and click on the
“Next” button.
Hereafter, only the
calibration procedure
of the 4A amplifier is
described but the
procedure is the
same for the other
boosters.
17) Connect the cell
cable and the two
DB15 connectors
between amplifier
and the calibration
boards as described
below and click on the
“Next” button.