Nozzle Cleaning (Manual)
- Press the "Posterior"( , ) button on the Auxiliary Control panel on the side of the seat without
occupying seat. The nozzle will fully extend. Gently clean the nozzle with a soft cloth or toothbrush.
- Press "Stop"( , ) button to retract nozzle to stand-by mode.
Selecting/Cancelling Silent Mode
- Beeping mode can be enabled or disabled.
- To select or cancel silent mode, press and hold down the "Stop"( , ) and "Massage"( , )
remote buttons simultaneously for approximately 3 seconds or until short beeps
Single short beep - Silent mode has been cancelled
Double short beeps - Silent mode has been set
- The new setting will automatically be saved if no other buttons are pressed.
ECONOMY (Energy Save Mode)
- Keep seat cover closed when not in use to prevent heat from being lost.
- Keep temperature set to low.
- Unplug the power cord if you do not plan to use the unit for a long period of time.
Saver On/ Off
- When pressing( , ) the energy saver LED on the main unit will turn on.
(press button again, the saver LED will turn off)
- Energy saver mode automatically maintains a water and
seat temperature of 89.6℉(32℃).
- When using bidet in saver mode, it is turned to automatic saver.
- When you rise from the seat, it goes into saver mode.
- Seat temperature is maintained 32℃.
Other energy saver tips
In order to save energy, please abide by the following instructions:
In energy saver mode, the seat heating
temperature could appear to be lower
than the actual temperature setting.
OFF
State
ON
State
Flashing
State
OCCUPIED
SENSOR
ENERGY
SAVER
POWER
BB-2000
DEODORANT
ENERGY
SAVER
POWER
BB-1700
171102_BB-1700,2000 USER's MANUAL.indd 17 2017-11-03 오전 11:28:11
To Next Page
Loading...
