BIO BIDET@ SLIM ZERO
Night-Light Instructions
I
Installing the Battery
nsert 4AA batteries, and put battery pack
in the control box. Replace the cover firmly.
I TO ensure proper polarity AA Batteries must be
used
2 During initial installation and replacement Of
Batteries,you must install based on the figure
provided above
3 During long periods Of non-use,it is recommended
to remove the batteries from the battery pack.
Note: Please check and clean battery contacts
prior to installation.
Single use AA Batteries are recommended
Remove the battery pack
2. Instructions
Install the bidet onto the toilet.
Operation
I. Press,the high light is on
2. Press again,the low light is on
3. 3rd Press,light is off
3. Replacing the battery
When the light turns red please replace the battery
Press Release Button
When replacingthe battery, press the
release button and the bidet, then remove
Repeatthe steps above to rep ace the
Batteries
Important
1. To prolong battery life,night light turns off
after 7 hours
2. Pressing the power button will reset the
7 hour timer
7
To Next Page
Loading...
