BIO BIDET@ SLIM ZERO
O SelfDiagnosisandSpecifications
• SelfDiagnosisandTroubleshooting
Status
Water is too low during
WASHIBIDET
Cause
l. LowwaterpressureOfthe unit
2. Lowwaterpressureofwatersupply
. Water shut-off valve is turned Off
2. Filterof T-shapedconnectoris clogged
NO water comes out
3.Filter of water inlet hose is clogged
during WASH/BIDET
4. Nozzle head is stuck
5. External water pressure is low
Water dropping from bowl
External water pressure is too high
when using the unit
Night light doesnt work Low batteries
Solution
During use, turn the lever forward or backward to highest setting
If the water supply pressure is too low, contact your local water utility.
Tum on the water shut-off valve
Clean the filter of T-shaped connector
Clean the filter of water inlet hose
Take Off and clean the nozzle head
Increaseexternalwaterpressure
The maximum water pressure of the unit is 110 PSI. If the water
supply pressure is above this, contact your local water utility.
Change batteries with brand new ones
If any failure still occurs after above troubleshooting, please contact support@Biobidet.com.
Caution
Specifications
Classification
Model NO
WASH water flow
Feminine water flow
Backflow Prevention
Water Supply
Water Pressure Range
Dimensions
Weight
Do not disassemble, repair, or remodel the unit,
as this will void warranty.
Description
Slim Zero
0.35-1.8Umin
0.35-1,8L/mjn
Check valve
Direct from water pipes
10-110 PSI
19.68" (l) X 14.30' (w) X2.25" (h)
4.85 lbs
9
To Next Page
Loading...
