Installation, Operation & Maintenance Guide ActiveOx Series 4
1-800-394-3458 003-OCT-2021 Bioclimatic.com
01 INTRODUCTION
1.1 Disclaimer
These instructions are submitted with the implicit understanding that:
1. This manual is to guide the user of Bioclimatic Air Systems (B.A.S.) equipment in the proper installation, operation, and
maintenance procedures to insure maximum equipment life with efficient operation.
2. The customer has assigned competent maintenance and operating personnel to the system described herein and will assume
operational and maintenance responsibility upon start-up of the system.
3. The customer will read and thoroughly examine the foregoing instructions and will notify the seller of any points not fully
understood, points of conflict or error.
4. The customer, in lieu of any notification to the contrary, has read and fully understands the operation of the system and
is aware of the hazards of corrosion, abrasion and fire or explosion and shall take the necessary steps in the operation of
equipment to control such hazards to the maximum extent possible.
5. Start-up assistance or field engineering service provided by B.A.S. shall in no way relieve the customer of responsibility for the
proper operation of the system.
1.2 Receiving
Products leaving the B.A.S. factory are inspected and in satisfactory operating condition. All equipment should be thoroughly
inspected when received. Although all units are properly packaged, rough handling in transit can cause breakage. Any shortage
or damage should be reported at once to the transportation company. Note the damage on the bill of lading before signing
for the shipment. No equipment may be returned to Bioclimatic without written authorization. Returned equipment sent
without authorization will be refused and returned to sender.
All products are shipped F.O.B. (Ex Works, FCA) Bioclimatic warehouse. Responsibility for all equipment passes to the buyer at the
time equipment is loaded onto the carrier’s truck.
1.3 Storage
If the generator unit(s) are not installed upon delivery, it should be stored in a cool, dry, weather protected location. Do not stack
any other equipment on top of the unit.
Continue on Next page
IMPORTANT: Any modifications to the unit by unauthorized personnel will void factory warranty.
The unit must be installed in accordance with the manufacturer’s instructions to preserve warranty.
To Next Page
