0.7,=,?4:9:1:91:=84?D
84>>4:9>
Manufacturer’s declaration electromagnetic emissions
The Gait Trainer III Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer III Treadmill should assure that it is used in such an
environment
84>>4:9?0>? :8;74,9.0 70.?=:8,290?4.09A4=:9809?
RF emissions CISPR 11 Group 1 The Gait Trainer III Treadmill generates
RF energy only for its internal functions.
Therefore, its RF emission is very low and is not
likely to cause any interference in nearby
electronic equipment
RF emissions CISPR 11 Class A The Gait Trainer III Treadmill is suitable for use
in all establishments other than domestic and
those directly connected to the public
low-voltage power supply network supplying
buildings used for domestic purposes.
Harmonic distortion Class A
EN 61000-3-2
Voltage fluctuations Complies
and flickerEN 61000-3-3
88@94?D
Manufacturer’s declaration electromagnetic immunity
The Gait Trainer III Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer III Treadmill should assure that it is used in such an
environment.
88@94?D?0>? 70.?=:8,290?4.
$0>?70A07 :8;74,9.070A07 09A4=:9809?E2@4/,9.0
Electrostatic discharge ± 6 kV contact Contact ± 6 kV Floor should be wood,
(ESD) ± 8 kV air Air ± 8 kV concrete or ceramic tiles.
IEC 61000-4-2 If floor is covered with
synthetic material, the
relative humidity should
be at least 30%
Electrical fast ± 2 kV for power lines Power ± 2 kV Mains power quality
transients/burst ± 1 kV for Signal ± 1 kV should be that of a
IEC 61000-4-4 input/output lines typical commercial or
hospital environment
Surge ± 1 kV differential mode ± 1 kV diff. mode Mains power quality
IEC 61000-4-5 ± 2 kV common mode ± 2 kV com. mode should be that of a
typical commercial or
hospital environment
CONTENTS
ELECTROMAGNETIC COMPATIBILITY — 10-2 —
To Next Page
Loading...
