EasyManua.ls Logo

biodex RTM 600 - Page 32

biodex RTM 600
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
88@94?D?0>?   70.?=:8,290?4.
$0>?70A07 :8;74,9.070A07 09A4=:9809?E2@4/,9.0
Voltage dips, short < 5% UT (> 95% of dip < 5% UT (> 95% of dip Mains power quality should
interruptions and in UT for 1/2 cycle) in UT) for 1/2 cycle be that of a typical commercial
voltage variations 40% UT (60% of dip 40% UT (60% of dip or hospital environment.
on power supply in UT) for 5 cycle in UT) for 5 cycle If a better mains power
input lines 70% UT (30% of dip 70% UT (30% of dip quality is required, it is
IEC 61000-4-11 in UT) for 25 cycle in UT) for 25 cycle recommended that the Gait
< 5% UT (> 95% of dip < 5% UT (> 95% of dip Trainer III Treadmill is
in UT) for 5 sec in UT) for 5 sec powered from an uninter-
ruptible power supply
Power frequency 3 A/m 3 A/m If image distortion occurs,
(50/60 Hz) magnetic it may be necessary to
field position the Gait Trainer III
IEC 61000-4-8 Treadmill display further
from sources of power
frequency magnetic fields
or to install magnetic shield-
ing. The power frequency
magnetic field should be
measured in the intened
installation location to assure
that it is sufficiently low
Conducted RF 3 Vrms, 3 Vrms, Portable and mobile RF
IEC 61000-4-6 150 KHz to 80 MHz 150KHz to 80 MHz communications equipment
should be used no closer to
any part of the Gait Trainer III
Treadmill, including cables,
than the recommended sep-
aration distance calculated from
the equation applicable to the
frequency of the transmitter.
Recommended separation
distance:
d = 1.2P 150 KHz to 80 MHz
d = 1.2P 80 MHz to 800 MHz
d = 2.3P 800 MHz to 2.5 GHz
where P is the maximum
output power rating of the
transmitter in watt (W)
according to the transmitter
manufacturer, and is the
recommended separtion
distance in meters (m).
Field strengths from fixed RF
transmitters, as determined
by an electromagnetic site
survey, should be less than
the compliance level in each
frequency range.
b
Interference may occur in the
vicinity of equip-
ment marked with
the following
symbol:
CONTENTS
— 10-3 ELECTROMAGNETIC COMPATIBILITY
Continued from previous page

Table of Contents

Related product manuals