BIOFLEX 180 - Application Of Treatment

26
Step 1
Place Array on the area to be treated. Apply to dermis (skin)
to obtain maximum transmission of light into the tissues. The
Treatment Array may be held  rmly in place either with the
straps provided or manually.
Step 2
Press the power button to turn the system on or o . You will
hear an audible double beep and the power button will turn
blue after it is turned on.
Step 3
Press the circle on the Controller Unit that corresponds to the
area of the body to be treated (e.g., face, knee, etc.). When
selected, the circle will turn blue.
Step 4
The Treatment Stage of the BioFlex 180 automatically selects
Stage 1 (recommended for at least the  rst  ve treatments or
longer). Press the button again for Stage 1 - 4, as required.
Step 5
Press the Start/Pause button to begin the treatment. There
will be an audible beep and the countdown timer will start.
The length of each treatment varies depending on the area
selected. For optimal results, run the treatment to completion
(until the timer signals the termination).
If you need to stop or pause your treatment for any reason,
press the Start/Pause button. Pressing the Start/Pause button
again will resume your treatment.
Step 6
Press the Stop button at any time to pause the treatment.
Press Stop twice to cancel the treatment.
Application Of Treatment