To Next PageTo Next PageWhy am I getting a Cassette Data BUS Malfunction error on my bioMerieux Laboratory Equipment?
A Cassette Data BUS Malfunction on your bioMerieux Laboratory Equipment could be due to electronics failure. Check the +5 VDC, +/-12 VDC @ TP7, 6, and 4 on the Main Interface Board. If the voltages are correct, replace the SCS I/O PCB Assembly. If voltages are low or not detected, see Power Supply Troubleshooting.
What to do if I get an ERROR - No cassette memory on bioMerieux Laboratory Equipment?
If you receive an 'ERROR - No cassette memory' message on your bioMerieux Laboratory Equipment, it may be because the cassette was removed or shifted during data transfer. Reposition the cassette against the contacts and repeat data entry.
How to troubleshoot a bioMerieux Laboratory Equipment SCS that will not start?
If your bioMerieux Laboratory Equipment SCS won't start, verify that the AC power switch is in the ON position and that the AC line cord is properly connected to a powered receptacle. Also, check for proper voltages at the power source and inspect the AC power switch fuses.
What to do if bioMerieux Laboratory Equipment SCS Does Not Start (“Power Up”)?
If your bioMerieux Laboratory Equipment SCS doesn't power up, check that the power cord is plugged into a powered receptacle and inspect the power switch fuse. Verify the supply voltage on both sides of the switch and check the voltage test points on the SCS I/O PCB Assembly. If all voltages are absent or improper, the DC Harness might not be connected correctly, or the Power Supply Board may be defective and need replacement.
How to fix a Defective CRC from Cassette data transfer (eternal loop of message) on bioMerieux Laboratory Equipment?
If you are experiencing a defective CRC from cassette data transfer resulting in an eternal loop message on your bioMerieux Laboratory Equipment, the button memory device may be defective. Replace the button memory device if it cannot be erased.
General| Type | Automated Microbiology Identification and Antimicrobial Susceptibility Testing System |
|---|---|
| Applications | Bacterial and antimicrobial susceptibility testing |
| Capacity | Varies depending on the model; up to 64 cards in VITEK 2 XL |
| Antimicrobial Susceptibility Testing (AST) Database | Comprehensive database of antimicrobial agents and breakpoints |
| Incubation Time | 4-18 hours depending on organism and test type |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Software | VITEK 2 Software for data management and analysis |
