BIOSTAR BIOS asher
BIOSTAR BIOS Flasher is a BIOS ashing utility providing you an easy and simple
way to update your BIOS via USB pen drive.
1. This ulity only allows storage device with FAT32/16 format and single paron.
2. Shung down or reseng the system while updang the BIOS will lead to system boot
failure.
The BIOSTAR BIOS Flasher is built in the BIOS ROM. To enter the utility, press <F12>
during the Power-On Self Tests (POST) procedure while booting up.
Updating BIOS with BIOSTAR BIOS Flasher
1. Go to the website to download the latest BIOS le for the motherboard.
2. Then, copy and save the BIOS le into a USB ash (pen) drive.
3. Insert the USB pen drive that contains the BIOS le to the USB port.
4. Power on or reset the computer and then press <F12> during the POST process.
5. After entering the POST screen, the BIOS-
FLASHER utility pops out. Choose [fs0] to search for
the BIOS le.
6. Select the proper BIOS le, and a message asking
if you are sure to ash the BIOS le. Click Yes to start
updating BIOS.
7. A dialog pops out after BIOS ash is completed,
asking you to restart the system. Press the [Y] key to
restart system.
8. While the system boots up and the full screen logo shows up, press <Delete>
key to enter BIOS setup.
After entering the BIOS setup, please go to the Save & Exit, using the Restore Defaults
function to load Optimized Defaults, and select Save Changes and Reset to restart the
computer. Then, the BIOS Update is completed.
All the informaon and content above about the soware are subject to be changed
without noce. For beer performance, the soware is being connuously updated. The
informaon and pictures described above are for your reference only. The actual informaon
and sengs on board may be slightly dierent from this manual.
To Previous Page
Loading...
Need help?
General
