Biostar K8M800 MICRO AM2 Bios Setup Manual

K8M800 Micro AM2 BIOS Setup
24
VIA OnChip IDE Device
If you highlight the literal “Press Enter” next to the “VIA OnChip IDE Device” label and then
press the enter key, it will take you a submenu with the following options:

Figure 5.1: VIA OnChip IDE Device
OnChip SATA
This option allows you to enable the onchip Serial ATA.
The Choices: Enabled (default), Disabled.
SATA Mode
This option allows you to select SATA Mode.
The Choices: IDE, RAID (default).
IDE DMA Transfer Access
This option allows you to select IDE DMA Transfer Access.
The Choices: Enabled (default), Disabled.
OnChip IDE Channel 0/1
The motherboard chipset contains a PCI IDE interface with support for
two IDE channels. Select “Enabled” to activate the first and/or second IDE
interface. Select “Disabled” to deactivate an interface if you are going to install a
primary and/or secondary add-in IDE interface.
The Choices: Enabled (default), Disabled.

Biostar K8M800 MICRO AM2 Specifications

General

Brand	Biostar
Model	K8M800 MICRO AM2
Category	Motherboard
Language	English