To Next PageTo Next PageWhat to do if my Biostar N68S3B Motherboard has no power?
If your Biostar Motherboard shows no power, ensure the power cable is securely plugged in. If the issue persists, try replacing the power cable.
How to fix boot issues on Biostar N68S3B after installing a second hard drive?
If your Biostar Motherboard cannot boot after installing a second hard drive, set the master/slave jumpers correctly. Then, run the SETUP program and select the correct drive types.
What to do if Biostar N68S3B shows 'Invalid Configuration' or 'CMOS Failure'?
If your Biostar Motherboard displays an 'Invalid Configuration' or 'CMOS Failure' message, review your system’s equipment and ensure the correct information is in the setup.
General| Number of memory slots | 2 |
|---|---|
| Maximum internal memory | 8 GB |
| Supported memory clock speeds | 800, 1066, 1333 MHz |
| Processor socket | Socket AM3 |
| Processor manufacturer | AMD |
| Maximum number of SMP processors | 1 |
| Power fan connector | Yes |
| USB 2.0 ports quantity | 4 |
| Firewire (IEEE 1394) ports | 0 |
| Audio chip | VIA VT1708B |
| Power source type | ATX |
| Motherboard chipset | Nvidia MCP68S |
| Audio output channels | 6.1 channels |
| Motherboard form factor | micro ATX |
| Compatible operating systems | Windows XP/Vista/7 |
| Graphics card | GeForce 7025 |
| Maximum graphics card memory | 512 MB |
| Parallel processing technology support | Not supported |
| RAID levels | 0, 1 |
| LAN controller | Realtek RTL8201CL |
| Networking features | Fast Ethernet |
| BIOS type | - |
Weight and Dimensions| Depth | 170 mm |
|---|---|
| Width | 235 mm |
Explains how to enter and navigate the BIOS setup utility.
Displays and allows configuration of CPU-related settings.
Sets the order in which devices are checked for booting.
Configures the boot sequence for installed hard disk drives.
Controls the CPU clock speed for performance tuning.
Controls the PCI-Express clock speed for performance tuning.
Manually configures DRAM timing parameters for performance.
Configures memory settings like interleaving and clock modes.
Saves all configuration changes to CMOS and exits setup.
