Biostar K8M800 MICRO AM2 Bios Setup Manual

K8M800 Micro AM2 BIOS Setup
28
Super IO Device
Press Enter to configure the Super I/O Device.

Figure 5.3: Super IO Device
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial
ports.
The Choices: 3F8/IRQ4 (default), Disabled, Auto, 2F8/IRQ3,
3E8/IRQ4, 2E8/IRQ3.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Biostar K8M800 MICRO AM2 Specifications

General

Brand	Biostar
Model	K8M800 MICRO AM2
Category	Motherboard
Language	English