To Next PageTo Next PageWhat to do if Biostar M7VIQ Motherboard has no power at all?
If your Biostar motherboard has no power, and the power light doesn't illuminate, the fan inside the power supply doesn't turn on, and the indicator light on the keyboard doesn't turn on, ensure the power cable is securely plugged in. If that doesn't work, try replacing the power cable.
What to do if Biostar M7VIQ system only boots from CD-ROM?
If your Biostar motherboard system only boots from CD-ROM, but the hard disk can be read and applications can be used, back up data and application files. Then, reformat the hard drive and re-install applications and data using backup disks.
What to do if after installing second hard drive Biostar Motherboard cannot boot?
If your Biostar motherboard cannot boot after installing a second hard drive, set master/slave jumpers correctly and run the SETUP program to select the correct drive types.
What to do if Biostar M7VIQ screen message says “Invalid Configuration” or “CMOS Failure.”?
If your Biostar motherboard displays an “Invalid Configuration” or “CMOS Failure” message, review the system’s equipment and ensure the correct information is in the setup.
General| Form Factor | Micro ATX |
|---|---|
| Maximum Memory | 2 GB |
| USB Ports | 4 x USB 2.0 |
| Expansion Slots | 1 x AGP, 3 x PCI |
| Onboard LAN | VIA VT6103 10/100Mbps Fast Ethernet |
| Storage | 2 x IDE |
| Audio | AC'97 Audio |
| LAN | VIA VT6103 10/100Mbps Fast Ethernet |
Lists included hardware and software for the motherboard.
Details CPU and system fan header pin assignments for installation.
Provides step-by-step instructions for installing DDR memory modules.
Describes the jumper for clearing CMOS settings.
Details the jumper for selecting CPU frequency.
