EasyManua.ls Logo

Biostar M7VKQ User Manual

Biostar M7VKQ
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
M7VKQ
Federal Communications Commission
(F.C.C.) Statement
This device complies with Part 15 of the FCC Rules. Operation of this device is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Accessories: This device has been tested and found to comply with the limits of a
Class B digital device; the accessories associated with this equipment are as
follows:
1. Shielded serial cable. (Can be obtained from multiple retail outlets)
2. Shielded printer cable. (Can be obtained from multiple retail outlets)
3. Shielded video cable. (Can be obtained from multiple retail outlets)
4. Shielded power cord. (Provided by manufacturer)
These accessories are required to ensure compliance with FCC Rules. It is the
responsibility of the user to provide and use these accessories properly.
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant of Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and radiates radio frequency energy
and, if you did not installed and used in accordance with the instructions, may cause
harmful interference in the radio communications. There is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, you are encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient / relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment into an outlet from a different circuit where the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications that is not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
Disclaimer
The vendor makes no representations or warranties with respect to the contents
here of and specially the vendor disclaims any implied warranties of
merchantability or fitness for any purpose. Further, the vendor reserves the right to

Table of Contents

Questions and Answers:

Biostar M7VKQ Specifications

General IconGeneral
Form FactorMicro ATX
Memory TypeDDR SDRAM
Memory Slots2
Max Memory2 GB
Onboard LAN10/100 Mbps
USB Ports6
Socket TypeSocket A (462)
ChipsetVIA KT400 / VT8235

Summary

Federal Communications Commission (F.C.C.) Statement

FCC Compliance and Operation Conditions

Device complies with FCC rules, subject to two conditions for operation.

Motherboard Description

Installation Procedures

Covers CPU, RAM, and general motherboard installation guidance.

BIOS Setup

Standard CMOS Features

Details standard configurable options for date, time, and drives.

Advanced BIOS Features

Covers enhanced BIOS features like virus warning and boot order.

CPU Installation

CPU Installation Procedure

Step-by-step guide for installing a CPU into Socket A.

RAM Module Installation

Connectors, Headers & Jumpers

Power Management Setup

PnP/PCI Configurations

PC Health Status

Frequency Control

Trouble Shooting

System Power Issues

Troubleshoots problems related to no power, no fan spin, or no keyboard lights.

Booting Issues - Hard Disk/CD-ROM

Troubleshoots problems with booting from hard disk or CD-ROM.

Boot Failure After Second Hard Drive Installation

Troubleshoots system boot failures after installing a second hard drive.

Related product manuals