MCP6PB M2+/N68S BIOS Setup
39
<Trp> Row Precharge Time
The Choices: 6 clocks (default), 3 clocks, 4 clocks, 5 clocks.
<Tras> Minimum RAS Active T
The Choices: 18 bus clocks (default), 5-17 bus clocks.
Special Notice:
If the system’s freq uenc y that yo u are selected is not functioning, there are two methods
of booting-up the system.
Method 1:
Clear the CMOS data by setting the JCMOS1 ((2-3) closed)) as “ON” status. All the
CMOS d ata will be loaded as defaults setting.
Method 2:
Press the <Ins ert> key and Power button simultaneously, after that keep -on press ing the
<Ins ert> key until the power-on screen showed.
This action will boot-up the system according to FSB of the processor
It’s strongly recommended to set CPU Vcore and clock in default setting. If the CPU
Vcore and clock are not in default setting, it may cause CPU or M/B damage.
To Previous Page
Loading...
Need help?
General
