Motherboard Manual
26
Notices:
Not all types of AMD CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under “Overclocking Navigator Engine” item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is “Disabled”; the condition parameter should
be changed to “Enable” to proceed this test.
BIOS SETUP UTIL ITY
Main Advance d
PCIPnP Boot
Chipset T-Series
vxx.xx (C)Copyri ght 1985- 200x, Amer ican Mega trends, Inc.
Select Screen
Select Item
Change Option
General Help
Save and Exit
Exit
+-
F1
F10
ESC
T-Series Setti ngs
=========== Au tomate Ov erClock Sy stem ==== =======
============ M anual OverCl ock System ===== =======
Notice: Please Clear CM OS if syst em no dis play
after overclock ing.
BIO-unlocKING [Dis abled]
OverClock Navi gator [Nor mal]
> G.P.U Phase Control
Auto OverClock System [V6- Tech Engi ne]
CPU/HT Reference Clo ck (MHZ) [200 ]
CPU Configurat ion [Aut o]
Spread Spectru m [Dis abled]
> Over-Voltage Configur ation
> CPU FID/VID Control
> Hyper Transp ort Confi guration
> DRAM Timing Config uration
Integrated Mem ory Test [Dis abled]
Exit
Options
Enabled
Disabled
↓
BIOS SETUP UTIL ITY
Main Advance d
PCIPnP Boot
Chipset T-Series
vxx.xx (C)Copyri ght 1985- 200x, Amer ican Mega trends, Inc.
Select Screen
Select Item
Change Option
General Help
Save and Exit
Exit
+-
F1
F10
ESC
T-Series Setti ngs
=========== Au tomate Ov erClock Sy stem ==== =======
============ M anual OverCl ock System ===== =======
Notice: Please Clear CM OS if syst em no dis play
after overclock ing.
BIO-unlocKING [Dis abled]
OverClock Navi gator [Nor mal]
> G.P.U Phase Control
Auto OverClock System [V6- Tech Engi ne]
CPU/HT Reference Clo ck (MHZ) [200 ]
CPU Configurat ion [Aut o]
Spread Spectru m [Dis abled]
> Over-Voltage Configur ation
> CPU FID/VID Control
> Hyper Transp ort Confi guration
> DRAM Timing Config uration
Integrated Mem ory Test [Ena bled]
Exit
Options
Enabled
Disabled
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from “Enable” to “Disable”
to complete the test.