What to do if my BIRD Measuring Instruments unit locks up?
If your BIRD Measuring Instruments unit ceases to operate and locks up, the system may have become unstable. Turn off the power, wait 15 seconds, and then reapply power.
Why does my BIRD SignalHawk SH-36S-RM unit turn off?
Your unit might turn off due to an internal error; in this case, simply turn it back on and continue. Alternatively, the unit might have shut down because the battery was too low. If this is the case, operate the unit from the AC adapter.
Why does my BIRD SignalHawk SH-36S-RM Test Equipment unit operate erratically?
If your unit is operating erratically, the system may have become unstable. Turn off the power, wait 15 seconds, and then reapply power.
What to do if my BIRD SignalHawk SH-36S-RM Test Equipment unit ceases to operate (locks up)?
If your unit ceases to operate or locks up, it might be due to an unstable system. Turn off the power, wait 15 seconds, and then reapply power.
What to do if the keys do not respond on my BIRD Test Equipment?
If the keys on your unit are not responding, the unit may be locked up. Try turning the unit off and then back on.
What to do if my BIRD Test Equipment self test fails?
If the self-test fails, it indicates an error condition. Turn the unit off and then back on. If the problem persists, return the unit for service.
Why does my BIRD Measuring Instruments give inaccurate readings below 100 kHz?
If your BIRD Measuring Instruments unit gives inaccurate readings below 100 kHz, it is because the unit is not specified for use below this frequency, even though it can be set below 100 kHz for user convenience. Do not use the unit below 100 kHz.
Why is my BIRD Measuring Instruments unit operating erratically?
If your BIRD Measuring Instruments unit operates erratically, the system may have become unstable. Turn off the power, wait 15 seconds, and then reapply power.
Why are the keys not responding on my BIRD Measuring Instruments?
If the keys on your BIRD Measuring Instruments unit do not respond, the unit may be locked up. Turn the unit off and then back on to resolve this.
How to fix a BIRD Measuring Instruments unit that will not power up?
If your BIRD Measuring Instrument won't power up, the AC adapter might be damaged, in which case you should replace it. Alternatively, the battery may not be fully charged or could be damaged. Allow the battery to fully charge, or replace it.
General safety precautions for operating personnel, including warnings about live circuits and unattended servicing.
Specific warnings for handling batteries, including disposal and avoiding damage.
Diagram and description of the front panel controls and indicators for the PC model.
Step-by-step guide for basic spectrum analysis measurements.
Instructions for installing the PC software and drivers for the SignalHawk.
Procedures for installing the Rack-Mount unit into a standard equipment rack.
Steps for connecting the Rack-Mount via USB and configuring network connections.
Configuration of frequency range, start/stop frequencies, and span.
Adjusting resolution bandwidth, video bandwidth, and sweep parameters.
Adjusting display parameters like Autoscale, Reference, Attenuation, Preamp, Offset, Units, and Trace.
Using markers to analyze signals and setting limit lines for threshold detection.
Measures power at each frequency in the sweep range.
Measures frequency band bandwidth containing specified percentage of total signal power.
Measures total power over a frequency range, concentrated on the center frequency.
Measures relative power of frequency bands adjacent to a central channel.
Steps for installing Windows drivers and the PC Tool software.
Common problems, their possible causes, and suggested corrections.
Detailed specifications for Frequency, Amplitude, Measurements, and other features.
General| Brand | BIRD |
|---|---|
| Model | SignalHawk SH-36S-RM |
| Category | Test Equipment |
| Language | English |
To Next Page
