To Next PageTo Next PageWhat to do if my BIRD Measuring Instruments unit turns off by itself?
If your BIRD Measuring Instruments unit turns off, it could be due to an internal error; in this case, turn the unit back on and continue. Alternatively, the unit might have shut down because the battery was too low. If so, operate the unit from the AC adapter.
Why are the keys not responding on my BIRD Measuring Instruments?
If the keys on your BIRD Measuring Instruments unit do not respond, the unit may be locked up. Turn the unit off and then back on to resolve this.
What to do if my BIRD Measuring Instruments unit locks up?
If your BIRD Measuring Instruments unit ceases to operate and locks up, the system may have become unstable. Turn off the power, wait 15 seconds, and then reapply power.
Why is my BIRD Measuring Instruments unit operating erratically?
If your BIRD Measuring Instruments unit operates erratically, the system may have become unstable. Turn off the power, wait 15 seconds, and then reapply power.
What to do if the self test fails on my BIRD Measuring Instruments?
If the self-test fails on your BIRD Measuring Instruments unit, it indicates an error condition. Turn the unit off and then back on. If the problem persists, return the unit for service.
Why is the sweep too slow on my BIRD Measuring Instruments?
If the sweep is too slow on your BIRD Measuring Instruments unit, the bandwidth may be set too low. Increase the BW.
General| Brand | BIRD |
|---|---|
| Model | SignalHawk SH-36S-RM |
| Category | Test Equipment |
| Language | English |
General safety precautions for operating personnel, including warnings about live circuits and unattended servicing.
Specific warnings for handling batteries, including disposal and avoiding damage.
Diagram and description of the front panel controls and indicators for the PC model.
Step-by-step guide for basic spectrum analysis measurements.
Instructions for installing the PC software and drivers for the SignalHawk.
Procedures for installing the Rack-Mount unit into a standard equipment rack.
Steps for connecting the Rack-Mount via USB and configuring network connections.
Configuration of frequency range, start/stop frequencies, and span.
Adjusting resolution bandwidth, video bandwidth, and sweep parameters.
Adjusting display parameters like Autoscale, Reference, Attenuation, Preamp, Offset, Units, and Trace.
Using markers to analyze signals and setting limit lines for threshold detection.
Measures power at each frequency in the sweep range.
Measures frequency band bandwidth containing specified percentage of total signal power.
Measures total power over a frequency range, concentrated on the center frequency.
Measures relative power of frequency bands adjacent to a central channel.
Steps for installing Windows drivers and the PC Tool software.
Common problems, their possible causes, and suggested corrections.
Detailed specifications for Frequency, Amplitude, Measurements, and other features.
