Birlea CORONA 2+2 DRAWER CHEST User Manual

Vendor: S000242
Page 1 of 9
ASSEMBLY INSTRUCTIONS
CORONA 2+2 DRAWER CHEST
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR USING YOUR CORONA 2+2
DRAWER CHEST.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ASSEMBLY INSTRUCTIONS:
Please check contents and read instructions carefully before commencing assembly.
To avoid damages assemble the item on a soft, clean surface.
Assemble in the room of use.
HEALTH & SAFETY:
DO NOT use this item if any parts are missing, damaged or worn.
DO NOT use this item unless all fixings are secured.
Always use on a level, even surface.
It is recommended that two people handle and assemble the item.
Keep small parts out of the reach of children.
CARE & MAINTENANCE:
This product is manufactured in pine which is a wood with natural characteristics including knots, grains,
clusters or indentations.
On unpacking the item you may notice an odour due to the production process, however, this will disappear
after a period of time.
DO NOT place the item next to a radiator or direct sunlight as this item is susceptible to temperature
change. It is recommended to maintain an even room temperature with no sudden fluctuations.
For general cleaning use a duster or damp cloth (almost dry) not wet – do not use soap and water,
detergents, aerosol sprays or any polish as the use of these materials would invalidate any claims.
You may wish to re-treat the surface to maintain the original finish. This can be done using block wax (un-
perfumed). Please follow the manufacturer’s instructions carefully.
DO NOT place the item onto wet or damp flooring as staining may occur to the floor.
Periodically check all screws & fixings to ensure they are secure.
DO NOT push the item as this will damage the base.
Keep any sharp objects away from the item.
www.birlea.com

Birlea CORONA 2+2 DRAWER CHEST Specifications

General

Brand	Birlea
Model	CORONA 2+2 DRAWER CHEST
Category	Indoor Furnishing
Language	English

Summary

Important Information and Safety

Assembly Instructions Overview

Read instructions carefully before assembly and keep for future reference.

Health & Safety Precautions

Guidance on safe assembly and use, avoiding damage, and keeping parts away from children.

Care & Maintenance Advice

Instructions for cleaning, avoiding damage from temperature, and surface treatment.

Assembly Steps

Step 1: Prepare Frame Components

Insert dowels into panels and attach drawer runners to left and right panels.

Step 2: Attach Back Crossbeam and Front Frame

Connect the back crossbeam to side panels and attach the front frame.

Step 3: Attach Top Panel

Secure the top panel to the assembled frame using screws.

Step 4: Attach Support Block

Attach the support block to the centre drawer runner using hardware.

Step 5: Attach Side and Front Plinths

Attach the side plinths to the base and then the front plinth.

Step 6: Secure Back Panel

Attach the back panel to the main unit using hardware part E and a mallet.

Step 7: Assemble Small Drawers

Assemble the small drawer components using hardware parts C, D, and G.

Step 8: Assemble Medium Drawers

Assemble the medium drawer components using hardware parts C, D, and G.

Step 9: Assemble Large Drawers

Assemble the large drawer components using hardware parts C, D, and G.

Step 10: Secure Drawers and Final Hardware

Secure the drawers using hardware part B and insert hardware part F.