BIRO 11 - Operator Safety During Operation; Cleaning Procedure; Cleaning the BIRO Power Saw

7
OPERATION
SHARP MOVING BAND TYPE SAW BLADE
TO AVOID SERIOUS PERSONAL INJURY
ONLY Properly Trained Personnel Should Use This Equipment.
ALWAYS Keep Hands Clear of Band Type Saw Blade and Other Moving Parts.
NEVER Operate with Saw Guide Bar with Saw Guard in the Raised Position or the Saw Guard
Removed from the Saw Guide Bar.
ALWAYS Adjust the Saw Guide Bar with Saw Guard to Within ½” of Product to be Cut.
ALWAYS Use Safety End Cut Pusher Plate for Smaller Products or The Last Cuts of Product.
DO NOT Wear Gloves While Operating Machine.
ALWAYS Turn Off, Unplug from Power Source and Perform Lockout/Tag Out Procedures Before
Cleaning, Servicing or When Not in Use.
NEVER Leave Machine Unattended While the Saw is Running.
NEVER Operate Without All Warning Labels Properly Afxed to Machine and Wall Chart Posted.
A. TO PROCESS PRODUCT
1. Before starting power saw, adjust saw guide bar with saw guard to within ½”(13 mm) of product to be cut.
E
R
G
N
A
D
DO NOT Tamper With, Bypass, Alter or Modify this Equipment in Any Way From Its Original Condition.