Bison HangTime - Safety Pin Installation

17
15) Safety Pin Installation
It is advisable to restrict height adjustment from 10’ to 7’6” to ensure safe play.
Insert the Safety Rod (AA) into the tube on the back of the Vertical Post (A).
If a lower rim height is needed for abnormally low play, remove the Safety Rod
(AA) before adjusting any lower than 7’6”.
16) Protective Padding Assembly
Reattach padding. Attach using the Velcro on the back of the padding to secure it
to the system.
1) Insert the Safety Rod (AA) into tube on the back of the
Vertical Post (A).
2) Insert the locking pin through the hole in the tube and the hole in
the Safety Rod (AA).
3) Lock the locking pin as shown in figure above.
(AA)
(A)
REV. 10/10/17