Bison HangTime - Rim Height Indicator and Sticker

16
14) Rim Height Indicator and Sticker
Assembly
To apply the Rim Height Sticker (V),
first use a tape measure to raise the
top of the rim up to exactly 10’ from
the playing surface.
Use a pencil to make a mark on the Spring-Assist Cartridges (E) where the bottom
of the Orange Rim Height Indicator (G) stops. Then, peel and apply sticker to the
outside of Spring-Assist Cartridges (E) lining up the pencil mark with the 10’ mark on
the sticker. See image below for a diagram of a completed height indicator
assembly.
NOTE: It is advisable to wait up to two weeks to
allow the anchor footing to fully cure before
aggressive play.
REV. 10/10/17