Bison HHBD01SK-01 - User Manual

Other manuals for Bison HHBD01SK-01

Operating And Maintenance Manual30 pages

Questions and Answers

R
ricardofisherAug 5, 2025
How to troubleshoot a Bison HHBD01SK-01 Chain Hoists with no response from buttons?
- S
  smithseanAug 5, 2025
  If your Bison Chain Hoist isn't responding when you press the buttons, first, ensure it's getting the correct power supply. Then, inspect the cables and electrical components for any loose connections or damage. Also, check that the emergency stop button is not engaged; if it is, release it.
K
Kyle ElliottAug 11, 2025
What to do if Bison Chain Hoists is making a slipping or clicking noise?
- M
  Michael ParkerAug 11, 2025
  If your Bison Chain Hoist is making a slipping or clicking noise, it could be due to several reasons. First, check if the hoist is overloaded and decrease the load if necessary. Also, ensure that the power supply is sufficient. Another potential cause is a stuck load brake; in this case, open the hoist to expose the brake assembly and check if the brake is disengaging when no load is attached.
M
Matthew SmithAug 16, 2025
Why Bison HHBD01SK-01 Chain Hoists is responding but will not operate?
- D
  Dawn WoodsAug 16, 2025
  If your Bison Chain Hoist responds but won't operate, it might be because the load exceeds the hoist's capacity; try decreasing the load. Alternatively, there could be an obstruction in the chain's path. Try operating the hoist in reverse to loosen the chain, then clean and oil it.
R
Rhonda MiddletonAug 22, 2025
What to do if Bison Chain Hoists fails to hold suspended weight?
- J
  joshualindseyAug 22, 2025
  If your Bison Chain Hoist fails to hold a suspended weight, it could be due to dust or oil on the brake disc, in which case you should replace the brake disc. Another cause could be severe abrasion of the brake assembly, requiring you to replace the entire brake.
A
Anthony JonesAug 28, 2025
Why Bison Chain Hoists continues to operate after controls have been released?
- A
  Alexandra WhiteAug 29, 2025
  If your Bison Chain Hoist continues to operate after the controls are released, it's likely due to damaged contactors or push buttons, which will need to be replaced.