Bison PR98GHT - Pole Cap Installation; Securing Pole to Ground Anchor

7
14. Install Pole Cap (H) on to the top of the
Pole (B). See Figure 14.
13. Install the Rim (CC) using the hardware and
instructions provided with the Rim (CC).
Install Net.
15. Locate the four 5/8” X 1 1/2” Hex Bolts (R)
and 5/8” Lock Washers (S). Prepare them by
having the 5/8” Lock Washers (S) installed
and placed by the Ground Anchor (A).
16. Using at least 2 people, carefully lift on the backboard to raise the assembly to a vertical position. Fasten
the Pole (B) to the Ground Anchor (A) using the 5/8” X 1 1/2” Hex Bolts (R) and 5/8” Lock Washers (S).
Start with 2 in the rear bolt holes. Then install the other 2 in the front bolt holes. Finger tighten the four
5/8” X 1 1/2” Hex Bolts (R). Remove the 3/4” X 7” Hex Bolt (K) and 3/4” Hex Nut (L) from the rear slot
and replace it with a 3/4” X 2” Hex Bolt (T), 3/4” Flat Washers (M), and 3/4” Hex Nut (L). Fully tighten
the four 5/8” X 1 1/2” Hex Bolts (R) as well as the 3/4” X 2” Hex Bolt (T) and 3/4” Hex Nut (L).
See Figures 15 & 16.
Figure 14
Figure 15