Bissell 2007 Series - Filling Clean Water Tank: Antibacterial Formula; EasyFill Antibacterial Formula Method; Clean Water Tank Filling Precautions

www.BISSELL.com
7
5
Filling Your Clean Water Tank:
For Future Use if selecting Antibacterial Formula with EasyFill
1
4
32
Lift the tank straight
up to remove from the
machine.
The Clean Water
Tank is at the top
of the machine.
Clean Water Tank
(1 Gallon)
Dirty Water Tank
Unscrew the cap from the
tank. Add hot tap water to
the water fill line.
At the bottom of the Upper
Handle, align the tank with
the grooves and slide the
tank into place.
Firmly insert the full size
formula bottle into the cap
on the tank and squeeze
until formula reaches the
EasyFill line.
After filling the tank with
hot tap water, twist the
yellow cap back onto the
tank.
A few notes about fi lling the Clean Water Tank:
• Fill with hot (140°F/60°C MAX) tap water and add the appropriate
BISSELL® formula. DO NOT USE BOILING WATER. DO NOT HEAT WATER OR
TANK IN MICROWAVE.
• When using BISSELL Antibacterial formula: Only fi ll your Clean Water Tank
with the recommended amount of water and formula to achieve antibacterial
benefi ts.
NOTICE: Do not overwet carpet. Be careful not to run over loose objects or edges of area
rugs. Stalling the brush may result in premature belt failure.
NOTICE: BISSELL Antibacterial formula is only for BISSELL machines with EasyFill
System™.