Bissell ADVANCED 44L6 SERIES - Diverter Assembly Cleaning; Empty and Rinse Water Tank; Clean Difficult Ready Tools Dial; Remove and Clean Diverter Assembly

Operatis
14. Empty 2-in-1 water tank and rinse out,
following instructions on pages 9.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the dial
may need to be cleaned. To clean, first remove
nozzle and locate screw that holds the diverter
assembly in place. With a Phillips screwdriver,
remove the screw and set aside.
16. Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the dial
about 10 times clockwise and 10 more
times counter clockwise. This should free
up any debris.
17. Wipe diverter assembly with a soft cloth
and replace back on machine. Replace nozzle.
18. Return ReadyTools dial to FLOOR
CLEANING setting.
www.BISSELL.com
11
15. 16.
Screw
Run water through here