Bissell ADVANCED 44L6 SERIES - Deep Cleaner Assembly Guide; Step 1: Attach Upper to Lower Body; Step 2: Install Upper Hose Rack; Step 3: Secure Handle Assembly

www.BISSELL.com
5
Your deep cleaner comes in five easy to
assemble components:
Handle assembly
Upper body assembly
Upper hose rack
Lower body assembly
Lower hose rack
Three Phillips head screws are included and
can be found taped to the handle assembly.
The only tool you will need to assemble your
cleaner is a Phillips head screwdriver.
1. Slide upper body assembly onto lower
body and secure with two screws.
2. With the “tabs” on upper hose rack
pointing toward top of handle, attach upper
hose rack to handle assembly by sliding it to
top of handle until it can go no further. Turn
hose rack until it snaps into place.
3. Slide handle assembly down into upper
body until it will go no further and secure
with screw.
4. Attach lower hose rack to back of upper
body by pushing into open slots and sliding
down until it snaps into place.
5. Wrap flex hose around hose rack and
secure it into notched out holder as shown.
6. Keep flex hose locked in place with hose
secure latch.
Asmbly
WARNING
Do not plug in your deep cleaner until you have completely
assembled it per the instructions and are familiar with all
instructions and operating procedures.
1.
2.
3.
5.
6.
Ta b
Upper Hose Rack
Notch
4.
Hose
Secure
Latch