Need help?Do you have a question about the Bissell PET STAIN ERASER 2842 Series and is the answer not in the manual?
General| Brand | Bissell |
|---|---|
| Model | PET STAIN ERASER 2842 Series |
| Category | Cleaning Equipment |
| Language | English |
Remove the clean water tank, dirty water tank, and suction lens before proceeding.
Use a flathead screwdriver to push and open a piece on the machine's base.
Remove the corresponding piece located on the other side of the machine.
Push the two hooks at the base of the machine inward to facilitate removal.
Carefully pry off the back cover of the machine.
Use a flathead screwdriver to pry off the upper cover, lifting from multiple spots.
Release four locks to remove the PCBA cover, possibly using a flathead screwdriver.
Remove the screw on the PCBA plate using a Phillips-head screwdriver.
Remove the DC jack cover and its associated spring.
Remove the five screws shown using a Phillips-head screwdriver.
Wiggle the handle away from the left side and pry it off once loose.
Remove the two screws shown using a Phillips-head screwdriver.
Cut the red wire first, then others, wrapping each with electrical tape after cutting.
To Next Page