w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Assembly
The PowerEdge is shipped in three pieces:
Upper handle, Body, Foot
No tools are required for assembly.
1. Slide upper handle into body and push
in firmly until handle locks into place.
2. Slide foot onto body of unit until foot
locks into place.
3. Wrap power cord on back of unit.
Transporting unit
Place unit in upright position and tip
back to roll on rear wheels.
Power switch
The power switch is located on the top
of the body of unit.
Push switch ON (l) to vacuum and OFF
(O) when cleaning is complete.
1. Turn quick release cord wrap to remove
power cord; plug into electrical outlet.
2. Lightly press the foot of the vacuum and
pull handle back to detent.
3. Turn power switch to ON (I) position
4. Clean your hard floors, under cabinets,
and easily maneuver around furniture.
To clean along edges, align the end
suction points along the areas you want
to clean.
5. When finished cleaning, turn power
switch to OFF (O) position.
6. To store the unit, return handle to upright
position.
1.
1.
4.
2.
2.
3.
5
Operations
How to use your hard floor vacuum
Power
Switch
To Next Page
Loading...
