BitaTek PS800Z - Code Type Transmit

31
“set G1string” barcode.
Scan ASCII code barcode in appendix B.
Scan “End Configuration”
Repeat step 2 and step 3 if you wish to
setup G2 Insert Character.
Scan “End Configuration”
Position to insert character: Choose a
position to insert characters, when the
setting is zero, non-zero characters will not
be inserted.
Scan “Start Configuration”
Scan “The start position of barcode to insert
G1 string” for G1
Scan ASCII code barcode in appendix B.
Scan “End Configuration”
Repeat the steps the start position of
barcode to G2 string.
Scan “End Configuration”
5.3.3 Code Type Transmit：
Start Configuration
< Disable >
Enable