Bittium Tough Mobile 2 User Manual

Bittium Tough Mobile 2 Quick Start Guide
8
Security Notification
In case you see one of these texts during use:
“The always on security system has detected a hardware
protection event. As a security procedure, all data in the
phone has been erased.”
or
“The always on security system has detected power loss
on backup battery. As a security procedure, all data in the
phone has been erased.”
This can happen if
1) phone has received a heavy impact or an attempt
has been made to open the chassis; and/or
2) the phone has not been recharged for a long time.
If these notifications keep appearing try setting the
tamper detection level setting to Basic. If this does
not help contact your service or customer support.
Security wizard
The device is equipped with a Security Wizard
that is launched during the initial power up of the
device. Security Wizard is used to set up a number
of different device settings. Follow the on-screen
instructions by first setting a screen lock code.
The number of set up steps may vary depending
on the security features of the device.
Lock screen
Switching off the display locks the device.
The device also locks after a period of inactivity.
Switch the display off by pressing the power key
once.

Bittium Tough Mobile 2 Specifications

General

Display Size	5.2 inches
Resolution	1920 x 1080 pixels
Processor	Qualcomm Snapdragon 670
RAM	4 GB
Internal Storage	64 GB
Battery Capacity	3000 mAh
Operating System	Android 9.0 (Pie)
Rear Camera	12 MP
Front Camera	5 MP
GPU	Adreno 615
Expandable Storage	microSD, up to 256 GB
Water and Dust Resistance	IP67
Shock Resistance	MIL-STD-810G compliant
Connectivity	Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 5.0, NFC
GPS	Yes, with A-GPS, GLONASS, BDS, Galileo
Chipset	Qualcomm Snapdragon 670
SIM	Single SIM (Nano-SIM)
Security Features	Hardware-based security
CPU	Octa-core (2x2.0 GHz Kryo 360 Gold & 6x1.7 GHz Kryo 360 Silver)