5-2-1 Send Commands
The Windows driver serves to receive the content for print from an application and send it
to the printer. The “Send Commands” function allows for the addition of desired commands
at the start or end of the print content.
Addition of command at the beginning of the document.
Addition of command at the beginning of the page.
Addition of command at the end of the page.
Addition of command at the end of the document.
For more information on the hexadecimals that can be entered in “Start Doc”, “Start Page”,
“End Page” and “End Doc”, refer to the Control Commands Manual.
5-2-2 Line Feed
Enter a number between 0 and 99 for adding blank lines at the end of printing.
5-2-3 Form Feed
Enter a number between 0 and 99 for adding the form feed command (0x0c) at the end of
printing.
To Next Page
Loading...
Need help?
General
