BIXOLON SRP-270 Command Manual

Rev. 1.01
- 5 -
SRP-270
Control code Hexadecimal code Function
<ESC><BEL>n1 n2 1B 07 n1 n2 Adjust drive pulse width for peripheral
unit(Default setting)
<BEL> 07 Deferred drive command "A" for peripheral
unit 1
<FS> 1C Immediate drive command "B" for peripheral
unit 1
<SUB> 1A Immediate drive command for peripheral
unit 2
<EM> 19 Immediate drive command for peripheral
unit 2
<CAN> 18 Cancel print data in buffer
<ESC> "@" 1B 40 Initialize printer
<ESC> "e" "0"
<ESC> "e" <0>
1B 65 30
1B 65 00
FEED switch valid
(Default setting)
<ESC> "e" "1"
<ESC> "e" <1>
1B 65 31
1B 65 01
FEED switch invalid
<ESC> U n 1B 55 n Set or Cancel uni-direction mode
<ESC> - n 1B 2D n Set or Cancel underline mode
<ESC> "z" "1"
<ESC> "z" <1>
1B 7A 31
1B 7A 01
Set 1/6 inch line feed
<FF> 0C Page feed (form feed)
<ESC> d <0> 1B 64 00 Partial cut
<ESC> d <1> 1B 64 01 Partial cut
<ESC> "-" "1"
<ESC> "-" <1>
1B 5F 31
1B 5F 01
Select overline mode
<ESC> "-" "0"
<ESC> "-" <0>
1B 5F 30
1B 5F 00
Cancel overline mode
<ESC> "e" "1"
<ESC> "e" <1>
1B 65 31
1B 65 01
Set the control panel switch invalid
<ESC> "e" "0"
<ESC> "e" <0>
1B 65 30
1B 65 00
Set the control panel switch valid
<ESC> "f" "1"
<ESC> "f" <1>
1B 66 31
1B 66 01
Set the ON LINE switch invalid
<ESC> "f" "0"
<ESC> "f" <0>
1B 66 30
1B 66 00
Set the ON LINE switch valid

BIXOLON SRP-270 Specifications

General

Color	No
Maximum print size	-
Media thickness	76 mm
Print technology	Dot matrix
Power requirements	120-230VAC
Standard interfaces	Parallel, Serial