BIXOLON SRP-E302 - Page 104

SRP-E300/302
Ver. 1.01 BIXOLON
- 104 -
GS L
Function:
Set left margin
Code:
ASCII
GS
L
nL
nH
Hex
1D
4C
nL
nH
Decimal
29
76
nL
nH
Range:
0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
Default:
(nL + nH x 256)=0 (nL=0, nH=0)
Description:
This command sets the left margin specified to [(nL + nH x 256) x (horizontal motion units)].
Remarks:
■ The left margin is not effective in page mode. If the left margin is enabled in page mode, the setting is available when
the printer returns to standard mode.
■ When the setting is beyond the printable area, the left margin is automatically set to the maximum value of the
printable area.
■ Since the left margin is the same as the leftmost side of the printable area, the left side of the printable area is
changed according to the left margin specified.
■ The setting of this command remains effective until ESC @, printer reset or power cycling is executed.
Printable area
Left margin
Printing area width
Differences:
None