Labeling
Operating instructions GLP
2 -- 8
6.562.98.5.01.18
2.2 Notes concerning labeling
2.2.1 Changing presettings for labeling
If required, called up article data or any other presettings may be changed prior
to labeling. Such changed presettings can be stored either for current labeling
procedures only or permanently in the database. This is described in section 3
”PRESETTINGS FOR LABELING”.
2.2.2 Calling mode level T
The input and operating functions used most may be copied into the customer--
specific mode level T. Quick and simple operation and data entry is then possible.
Operating sequence Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] T -- Call mode level T if not yet done.
Switching the device off and back on causes the user to remain at mode level T.
2.2.3 Calling up a stored macro
Customer--specific macros made up for the data input or operation may be called
up at any time via the allocated key.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[RECORD] -- Call up the stored macro.
A -- Press the relevant key, e. g. A.
If created, enter the password for the macro called up.
The first input or selection function is automatically called. Successively enter or
preset the relevant data and acknowledge.
2
To Next Page
Loading...
