Labeling
Operating instructions GLP
2 -- 16
6.562.98.5.01.18
-- Shift the backing paper underneath the holding fishplates on the tape winder
and wind it anticlockwise by making a few turns.
-- Move back the swivel lever on the printer and close the printhead.
-- Have a few blank labels output by activating the [FEED] key.
-- Check the backing paper for properly winding up/off. Also check the backing
paper guide.
-- Move the housing cover back in place.
2.4.4 Replacing the thermal transfer tape on the GLP
If the labeler is operated with a thermal transfer tape, the tape may be replaced
after the end of the tape has been reached. The procedure is as follows:
-- Tilt the housing cover upward as described on the previous page.
-- Tilt the side part of the GLP160 holding on the plastic handle.
-- Open the printer using the swivel lever as described on the previous page.
-- Remove the wound up used thermal transfer tape and the remaining paper roll
from the takeup reel and take out of the printer.
-- Attach the new thermal transfer type roll to the right--ahnd takeup reel (see il-
lustrating below). Move the thermal transfer tape through the printer as shown
in the schematic drawing and clamp it underneath the fishplate of the tape
winder. Turn the tape winder clockwise by making some turns, so that the tape
winds up over small length.
New thermal transfer tape
Tape winder for the ther-
mal transfer tape
-- Move back the swivel lever on the printer and close the printhead.
-- Check the backing paper for correct winding up/off. Also check the backing pa-
per guide.
-- Move the housing cover back in place.
2
To Next Page
Loading...
