Labeling
Operating instructions GLP
2 -- 17
6.562.98.5.01.18
2.4.5
When cutting Linerless labels activate retract operation
If Linerless labels are to be cut, activate the retract operation to retract the labels
(see page 3 -- 143).
2.5 Labeling
The label type used should be checked prior to commencing labeling. Changing
the label roll is described in greater detail on pages 2 -- 15.
It is advisable to check the label for a correct article data printout after the issue
of the first label. This prevents the following labels from being incorrectly printed.
2.5.1 Labeling modes
The labeling mode is normally stored under the PLU data individually for each ar-
ticle. It is automatically called up on call of the PLU data. In the event that the label-
ing mode is not stored under the PLU data or if an article is to be labeled in a differ-
ent mode, the labeling mode may be preset directly (see page 3 -- 65). The
following labeling modes are offered:
-- Weight labeling (see page 2 -- 18)
weighing and labeling packages varying in weight
-- Fixed price labeling (see page 2 -- 19)
labeling packages with a preset fixed price
-- Fixed weight labeling (see page 2 -- 20)
labeling packages with the fixed weight preset and the price calculated on the
basis of unit price x fixed weight
-- Fixed value labeling (see page 2 -- 20)
labeling packages with the fixed weight and fixed price preset
2.5.2 Presetting the label printing release mode
If labels are to be automatically printed after the scale is in stable equilibrium in
labeling of weight--variable packages, the release mode must be set to ”Auto-
matic” (see page 3 -- 65). This mode must also be set if the next label is to be
printed after removal of the previous label in fixed price, fixed weight package la-
beling.
In the event that each label is to be individually released in fixed price, fixed weight
or fixed value package labeling, the release mode must be set to ”manual”.
2.5.3
GLP labeler connected to the packaging machine
If the GLP labeler is built on a packaging machine, products to be wrapped and
labeled must be placed on the scale integrated into the infeed conveyor belt of the
packaging machine. Depending on the labeling mode preset, the package is first
weighed or conveyed to the packaging machine via the infeed conveyor belt and
wrapped accordingly. The next product may then be applied to the scale etc.
As regards the GLP--PRIMA labeler and in the event that an error occurs, or if the
labeler has run out of labels, the labeler is set to STOP (display
--
). After
correction of error or after change of label roll, the labeler may be restarted by
activating the softkey ”auto. labeler” (display
+
).
2
To Next Page
Loading...
