Presettings for labeling
Operating instructions GLP
3 -- 21
6.562.98.5.01.18
Printing second weight on single or total labels
Depending on the selection, the 2nd weight may be printed on
customer--specific single or total labels.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
Article
data
Weight Print
weight
Weight
2
Print
wgt. 2
--
Call up selection menu.
On sing.
lab.only
Make this setting if the 2nd weight is to be printed on single labels
only (standard setting).
Single &
tot. lab.
Make this setting if the 2nd weight is to be printed on both single
labels and total labels.
On total
lab.only
Make this setting if the 2nd weight is to be printed on total labels
only.
Text to weight: fixed weight or nom. fil. quantit.
If articles are labeled with a fixed weight, ”Fixed weight” is printed out above the
weight as standard. If ”Nom. fil. quantit.” is to appear above the weight, make
the relevant selection here.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Article
data
Weight
Print
weight
[ETC] -- Call up the selection menu.
Wgt text
Fwgt net
N.f.q
F.wg.
Select ”N.f.g.” if this text is to be printed out on the label in lieu of
”Fixed weight”.
Standard setting: Fixed weight
(standard)
Fixed weight
Nominal
filling quantity
Text to weight: meat proportion or drained weight
If the operating mode ”With ingredient proportion” is set, (see page 3 -- 22), cu-
stomer--specific labels ”Meat port.” or ”Drained port.” may be printed out in a text
field provided for the calculated ingredient proportion.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Article
data
Weight Print
weight
-- Call up selection menu.
Wgt text
Drain.wgt
DrndMpro
Select ”Drnd” if this text is to be printed out in addition to the ingre-
dient proportion in lieu of ”Mpro”.
Standard setting: meat proportion (Mpro)
3
To Next Page
Loading...
