Bizerba GLP 80 - Page 173

Presettings for labeling
Operating instructions GLP
3 -- 35
6.562.98.5.01.18
3.1.9 Country (primary country)
A selection of a different primary country is only possible if a relevant acti-
vation is made at mode level 5.
Normally, the relevant primary country (mostly the country of installation) is preset
(fixed) either at mode level 5 or per PLU under the PLU data. If labeling is to be
carried out temporarily for another country, the relevant primary country may be
selected here. An overview of the selectable countries is given in section 2.1 of
the programming instructions. After presetting of the country, the relevant cur-
rency unit is indicated in the verification display of the labeler in addition to the unit
price and printed on labels together with both the unit price and the selling price.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Article
data
[ETC]
Country
-- Call up the selection menu.
[ ] , [ ] -- Select the country using the cursor keys
C -- or select the country by entering the initial letter, e. g. C for
Canada. In the event that several countries start with the same
initial letter, press the letter key until the required country is in-
versely presented.
OK <ENTER>
Country
Canada
Argentia
Ecuador
Cancel <ESC>
[ENTER] -- Acknowledge the selection and exit the selection menu.
The set country is inversely presented above the softkey.
3
Country
Canada