Presettings
Operating instructions GLP
3 -- 67
6.562.98.5.01.18
3.5.1.5 Label sequence: number
Prerequisites: fixed price, fixed weight or fixed value labeling mode and
”With label sequence”
are preselected (see below).
If a certain number of identical labels is required, the desired number may be input
here and the labels automatically printed in succession on the ejecting backing
paper (see page 2 -- 32). The number of labels may also be stored under the PLU
data and changed if necessary. If label sequences are to be successively printed
for different articles, the unit may be set to ”Label sequence + separation la-
bel” in order to ensure that a blank label is output every time the printout of the
preset number of labels for an article is completed (see page 2 -- 32).
Printing a label sequence combined with the total preselection
If the packages to be labeled are then, for example, packed in a carton for which
a carton total label is required, the number of packages per carton may be preset
as, e. g. ”with preset total 1”. After printout of the number of labels per carton, the
total label *1 is automatically printed. With the release mode set to ”Manual”, the
printout of the next label sequence must again be started with the [PRINT] key.
With the release mode set to ”Automatic”, printing of the label sequence is auto-
matically continued after printout of the total label until the preset number of labels
is reached. If the number of packages is unknown or the number of packages is
determined by the number of cartons, the value --1 (infinite) may be preset as the
number of packages. After startup with the [PRINT] key, the total label sequences
are printed up to the moment at which the procedure is stopped by means of the
[HOME] key.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe-
ling
Release
mode
Lab.sequ.:
number
-- Call up the input menu.
xx [ENTER] or [ETC] -- Enter the new value and acknowledge or save in the da-
tabase (see page 1 -- 32).
3.5.1.6 Label sequence: mode
If a larger number of labels is to be printed successively, the relevant mode is to
be set here (see section 2 -- 32).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe-
ling
Release
mode
Lab.sequ.:
mode
-- Call up the selection menu.
W. lab.
sequ.
Make this setting if a label sequence is to be printed. The input of
the relevant number of labels is described above.
W/o lab.
sequ.
Make this setting if the input of a number of labels is to be disabled
(standard setting).
Lab.seq.
+ sep. lab.
Make this setting if a label sequence is to be printed and a separa-
tion is to be output after the printout of this label sequence.
3
To Next Page
Loading...
